twisted.internet.stdioView Source (View In Hierarchy)
|Method||write||Write some data to the physical connection, in sequence, in a non-blocking fashion.|
|Method||writeSequence||Write an iterable of byte strings to the physical connection.|
|Method||loseConnection||Close my connection, after writing all pending data.|
|Method||getPeer||Get the remote address of this connection.|
|Method||getHost||Similar to getPeer, but returns an address describing this side of the connection.|
|Method||registerProducer||Register to receive data from a producer.|
|Method||unregisterProducer||Stop consuming data from a producer, without disconnecting.|
|Method||stopProducing||Stop producing data.|
|Method||stopReading||Compatibility only, don't use. Call pauseProducing.|
|Method||startReading||Compatibility only, don't use. Call resumeProducing.|
Write some data to the physical connection, in sequence, in a non-blocking fashion.
If possible, make sure that it is all written. No data will ever be lost, although (obviously) the connection may be closed before it all gets through.
|Parameters||data||The data to write. (type: |
Write an iterable of byte strings to the physical connection.
If possible, make sure that all of the data is written to the socket at once, without first copying it all into a single byte string.
|Parameters||data||The data to write. (type: an iterable of |
Close my connection, after writing all pending data.
Note that if there is a registered producer on a transport it will not be closed until the producer has been unregistered.
Get the remote address of this connection.
Treat this method with caution. It is the unfortunate result of the CGI and Jabber standards, but should not be considered reliable for the usual host of reasons; port forwarding, proxying, firewalls, IP masquerading, etc.
Register to receive data from a producer.
This sets self to be a consumer for a producer. When this object runs out of data (as when a send(2) call on a socket succeeds in moving the last data from a userspace buffer into a kernelspace buffer), it will ask the producer to resumeProducing().
resumeProducing will be called once each time data
pauseProducing will be called whenever the write
buffer fills up and
resumeProducing will only be called when
|Raises||RuntimeError||If a producer is already registered.|
Stop consuming data from a producer, without disconnecting.
Stop producing data.
This tells a producer that its consumer has died, so it must stop producing data for good.
Compatibility only, don't use. Call pauseProducing.
Compatibility only, don't use. Call resumeProducing.